arXiv preprint ·
Electrothermal behavior of superconducting nanowires buried in a commercial CMOS process
- Published
- Source
- arXiv preprint, posted before peer review
- Original
- Read it at arXiv
- Topics
Abstract
Superconducting films native to a commercial CMOS process enable co-integration of superconducting devices (high-kinetic-inductance elements and nanowire detectors) with cryogenic CMOS on one monolithic die. Such films are buried in the front-end-of-line, beneath the back-end-of-line metal stack, an environment that might quench a self-heated hot spot. Current-voltage characteristics are reported for titanium nitride (TiN) nanowires in the polycrystalline-silicon resistor layer of a 22 nm FD-SOI process, and measured retrapping currents are compared with thermal models for longitudinal conduction to the contacts and interfacial phonon cooling into the stack. The wires are strongly hysteretic, with switching-to-retrapping current ratios I_sw/I_r of 7.4-9.8, sustaining a normal hot spot. For two wires of length ell = 50 micrometers and widths W = 0.50 and 1.00 micrometers, over bath temperatures T_b = 0.15-1.19 K, I_r follows the interfacial form (T_hs^n - T_b^n)^(1/2) with n = 4 (T_hs, the effective hot-spot temperature), and is strongly inconsistent with the (T_hs - T_b)^(1/2) constant-kappa longitudinal-conduction limit; free-exponent fits give n = approximately 4.8-5.0. An effective cooling coefficient Sigma_K = 7.9(3) W/(m^2 K^4) describes the data: 31(21) times below the acoustic- (diffuse-) mismatch value for a single clean interface, and approximately 12 times below the lowest previously reported comparable nanowire coefficient. The model-based film thermal conductivity is kappa = approximately 20 mW/(m K). Across lengths ell = 1-50 micrometers, I_r matches neither ell^(-1) of pure longitudinal conduction nor ell^0 of pure interfacial cooling; a two-channel model reproduces I_r(ell) with crossover length ell* = approximately 3.5 micrometers predicted, to an O(1) prefactor, from Sigma_K and kappa.
The authors’ abstract, as arXiv lists it. arXiv’s listings, abstracts included, are free for anyone to reuse.
Read it on ReadSearch
Each opens after you create an account, and brings you back to this paper.
More in Instrumentation & Detectors
Scanless quantum Fourier-transform mid-infrared spectroscopy for solids and surface analysis
Characterization and Active Control of Position-Dependent Timing Dynamics in Superconducting Strip Detectors
Multimode radiation pressure actuation of a mechanical resonator using a spatial mode sorter
High-Voltage Optocoupler Amplifier for Electrostatic Actuators
Towards noble gas quantum optical magnetometry using direct ultraviolet detection
Get the few papers worth your time in Instrumentation & Detectors every morning.
ReadSearch reads the new papers in your field each day and brings you the few worth reading, each with its key finding in a sentence.